Model : KIT 5

Wireless High-frequency Module Test A Rule

This KIT is especially designed for testing TWS-4HIP.

Specification

• 1.The Relay A and Relay B on the Receiver homologized several to the Dip switch 1 and Dip switch 2 on the 2 Pin of Transmitter.
• 2. When Dip Switch turn on, the Relay action pattern : Transmitter output once, the Relay is On, and When the transmitter output again, the relay is No.
• 3.When Dip Switch turn to off, the Relay action pattern are : Transmitter always keeping output staus, the Relay will keep on NO. situation, till the Transmitter no longer to transmite Data, the Relay will return to No status.
• 4.The buttom A and B on the Transmiiter, which are control several to the Relay A and Relay B on the Receiver (A Buttom is Control Relay A, and Buttom B for Relay B) This Demo PCB is special design for TWS-4HIP(2W) High frequency Trasmitter, which contain two parts :
  
  • (1). Voltage Power
  • (2). Analogue data imput

Analogue data impot

Take advantage of simple Decoding supply a series data to imput to Module.

Voltage Power

• Due to TWS-4HIP working currency waste a lot, therefore, this Module Demo PCB have supplied a low currency power which provide Module Demo Testing.
• The incording code of Receiver is used Aerodecording, which direct decord to the cacho memory of the Receiver.

Operation

• Push the set buttom of Receiver, the LED on the Receiver will keep blinking, (it mean under receiving code condition), Press any key of Transmitter for 3 secend, the LED of Transmitter do not blinking, It is means the Code is finished setting.
• Notice : If any modify of code on the Receiver, the Receiving Code must be re-setting

I have a question: